Next: *CONTROLS Up: Input deck format Previous: *CONTACT PAIR Contents
Keyword type: step
This option is used to print selected contact nodal variables in file jobname.dat. The following variables can be selected:
- Relative contact displacements (key=CDIS)
- Contact stresses (key=CSTR)
- Contact spring energy (key=CELS)
Contact quantities are stored for all slave nodes in the model. The relative contact displacements and the stresses consist of one component normal to the master surface and two components tangential to it. Positive values of the normal components represent the normal material overlap and the pressure, respectively. The energy is a scalar quantity.
There are three parameters, FREQUENCY, TIME POINTS and TOTALS. FREQUENCY and TIME POINTS are mutually exclusive.
The parameter FREQUENCY is optional, and applies to nonlinear calculations where a step can consist of several increments. Default is FREQUENCY=1, which indicates that the results of all increments will be stored. FREQUENCY=N with N an integer indicates that the results of every Nth increment will be stored. The final results of a step are always stored. If you only want the final results, choose N very big. The value of N applies to *EL FILE, *ELPRINT, *NODE FILE, *NODE PRINT, *FACE PRINT and *CONTACT PRINT. If the FREQUENCY parameter is used for more than one of these keywords with conflicting values of N, the last value applies to all. A frequency parameter stays active across several steps until it is overwritten by another FREQUENCY value or the TIME POINTS parameter.
With the parameter TIME POINTS a time point sequence can be referenced, defined by a *TIME POINTS keyword. In that case, output will be provided for all time points of the sequence within the step and additionally at the end of the step. No other output will be stored and the FREQUENCY parameter is not taken into account. Within a step only one time point sequence can be active. If more than one is specified, the last one defined on any of the keyword cards *NODE FILE, *EL FILE, *NODE PRINT, *EL PRINT or *FACE PRINT will be active. The TIME POINTS option should not be used together with the DIRECT option on the procedure card. The TIME POINTS parameters stays active across several steps until it is replaced by another TIME POINTS value or the FREQUENCY parameter.
The first occurrence of an *CONTACT PRINT keyword card within a step wipes out all previous nodal variable selections for print output. If no *CONTACT PRINT card is used within a step the selections of the previous step apply, if any.
The parameter TOTALS only applies to the energy. If TOTALS=YES the sum of the contact spring energy for all contact definitions is printed in addition to their value for each node in the set separately. If TOTALS=ONLY is selected the sum is printed but the individual nodal contributions are not. If TOTALS=NO (default) the individual contributions are printed, but their sum is not.
If the model contains axisymmetric elements the spring energy applies to a segment of . So for the total spring energy this value has to be multiplied by 180.
- *CONTACT PRINT
- Identifying keys for the variables to be printed, separated by commas.
Example: *CONTACT PRINT CDIS
requests the storage of the relative displacements in all slave nodes in the .dat file.
Example files: beampkin, beamrb.
Next: *CONTROLS Up: Input deck format Previous: *CONTACT PAIR Contents guido dhondt 2012-10-06